• Archived - Moved to webste

Printing and Assebly

While it was a little bit flimsy, it did work! I would recommend beefing it up a bit though.

Assembly

Once your two parts are printed, using either a regular press or a heat press:

• [ ] Press all x8 5mm x 3mm magnets into their holes in each corner.
• [ ] Heat press all x3 1/4” heat threaded inserts into the PART A - Bottom

<aside> ⚠️ QUICK NOTE: I made the holes for the 5mm (D) magnets 5.2mm, so it should just be enough to push the magnets into place if you just wanted to put a glob of super glue in the hole. Or, you can use a head press to push the magnets into place.

</aside>

Here is what the MUIN fume extractor looks like on it’s own:

And here is what it looks like disassembled. The part holding the filter (far right of below image) can be removed as it’s not needed. Once

Take the “PART A - BOTTOM” part and lay it flat on the desk. Take the MUIN fume extractor with the filter facing up towards you, press the fume extractor into the PART A. The bottom feet of the extractor are mean to

The bottom feet of the extractor are mean to slide into the cutout grooves of the PART A piece.